Dual-LS 600 - 1200

Double measurements:

Under certain circumstances it can become necessary to measure two velocities  parallel or sequentially to get demanded data (Information). The following list shows some examples of double measurements, but makes no claim to completeness.

- To make sure that the measurement is correct (backup measurement, reliability, redundancy)
- Important and/or not repeatable measurements
- QM guidelines and/or specifications
- Customers/Contractors wish or specification
- Customer specific test setup, that requires 2 velocities (e.g. before and after a target or a other special given problem)
- Calculationof the ballistic coefficient
- Required by law
- Forensic investigations

 In all these cases our measuring systems offer solutions, supported by the miscellaneous possibilities of the BMC 21 software.

The new designed High End lightbarrier family LS 1200 connect are highly precise unidirectional static Infrared lightbarriers. Because of the size, the lightbarriers are suitable for military use, forensic analysis, ballistic labs, aviation ...

The Lightbarrier family LS xx00 consists at the moment of four members, LS 600, LS 800,
LS 1000 and LS 1200 with Measuring windows from 600 x 400mm to 1200 x 400mm!

The Lightbarrier family offers the following technical data:

Caliber Range: 4 .. 40mm
Velocity range: 5 .. 3000m/s
Standard temparatur range: 0 - 40° Celsius without condensation.
Extended temparature range possible!
Accuracy: < 0,1%
Very large Sensor areas from
600 x 400 mm up to 1200 x 400mm .

(see the picture above for the scale of the lightbarriers size)

The standard Measuring base is 1000mm. Every other user defined base is possible.
The Signal output is Analog positiv
The Output connector type is 50 Ohm BNC.
The Output amplitude depends on the used caliber and the gain settings.
The Power supply supports a wide - 64 Volt AC range and can be used worldwide.
Custom built solutions to solve special problems are possible and welcome.
The LS 600 consists of two single Lightbarriers, mounted with 1000mm distance (standard).

Both lightbarriers are powered from their own power supply.
The lightbarriers are featured with a RS 485 interface which makes the units able to work in a RS 485 network with up to 32 different devices.

The user can check and change all variable Lightbarrier parameters via RS 485 interface from the desktop of the Win32 Software. Only with the mouse on the table.. Very important for the users safety: No direct operation at the lightbarrier is necessary, no user has to move in the area of danger. Software language is english, german or can be user defined with a language editor.

Weight: approx. 16 .. 24kg (LS 600 - 1200)
Frame material: Anodized aluminum
Complete Power consumption: ~ 16 W